Time your watch on your phone or bench.
Rate, amplitude and beat error from your phone's mic, a computer mic or a piezo pickup. It all runs in your browser, and nothing gets uploaded.
On a phone, set the watch face up right on the mic, usually the small hole on the bottom edge, in a quiet room. A clip-on pickup works even better.
The first time on each phone or computer, it checks the mic's clock so readings are accurate. That takes about 30 minutes with no extra gear, 10 with a quartz watch, or 1 with a GPS timing signal. After that it's saved.
Check your mic's clock
Every phone and sound card keeps slightly different time, and that shows up as rate error. This check runs once per device, and measuring unlocks when it's done.
- Input
- Reference
- Signal
- Measure
- Save
Leave at 0 if you don't know it. A typical quartz watch is within about 0.5 s/d.
Advanced: enter a correction by hand
Only if you measured this sound card elsewhere. Every result will be flagged.
Place the quartz watch on the mic or pickup, the same way you'll place watches you test.
0 reference pulses heard in the last 5 s
- Elapsed
- 0:00
- Correction
- measuring
- Stability
- measuring
Keep the bench still. The run finishes on its own once the reading has held steady long enough.
ticktock